Operation Instructions; Timer Setting - eeese Otto Bedienungsanleitung

• Ensure the supply power is in correspondence with the value on the nameplate
and power outlet needs to be grounded.
• Ensure the water tank is correctly fitted before the dehumidifier can be switched on.
• If the dehumidifier is turned off and then turned back on again immediately, it will
take approximately 3 minutes to reach full power (compressor back to work).
• If the dehumidifier is switched off by a power cut, it will automatically switch back
on once the power is restored.
• The dehumidifier works best at normal room temperature, its efficiency is reduced
if the ambient temperature falls to below 15°C.
• Turn on the power and run the machine as per instructions below.
5.

Operation Instructions

Switch On / Switch Off The Unit
1. Connect the mains lead to socket.
2. Press Power button once to turn on the unit. By default, it runs
on Manual Dehumidifying Mode.
3. Press Power button once again to turn off the unit.
Humidity Setting Control
Press Manual button once to enter Manual Dehumidifying Mode or to select desired level
of humidity from CO-30%-35%-40%-45%-50%-55%-60%-65%-70%-75%-80%-CO

Timer Setting

At ON Mode, press Timer button consecutively to select your preferred timer duration for
automatic shutoff setting. Its corresponding Timer indicator will be displayed on screen.
Oscillating Flaps
Oscillating flap oscillates from different angle for better air circulation and optimal
diffusion of the dehumidified air throughout the room.
WIFI Function
Press the Oscillation button for 2 seconds to activate the WIFI function and enter into
the distribution network mode. During the network configuration, the WIFI indicator
flashes and after the WIFI is connected, the icon is on.
See below section Connection to WIFI for detalied settings.
Press the Oscillation button for 2 seconds and you can disconnect to the WIFI.
MV-2552-03--2021 eeese-air-care.com © All rights eeese air care aps
UK
77