Prior To Operation; Operation Instructions - eeese Anna Bedienungsanleitung

UK
4.

Prior to Operation

• Check the dehumidifier for any transport damage. In case of damage, you should
contact our eeese service line immediately.
• Place the dehumidifier in an upright position on a stable, flat surface.
• Make sure that the mains lead is easily accessible and is not damaged by sharp
edges or is crushed in any way during use.
• Ensure the dehumidifier is at a safe distance at least 50 cm away from a wall
or furniture and has air space on all sides.
• The machine must stand upright for at least 1 hour before it is used for the first time
• If any part of your house suffers from severe humidity, the dehumidifier can be
placed there first and then moved to another part of the house later.
• Ensure the supply power is in correspondence with the value on the nameplate
and power outlet needs to be grounded.
• Ensure the water tank is correctly fitted before the dehumidifier can be switched on.
• If the dehumidifier is turned off and then turned back on again immediately, it will
take approximately 3 minutes to reach full power (compressor back to work).
• If the dehumidifier is switched off by a power cut, it will automatically switch back
on once the power is restored.
• The dehumidifier works best at normal room temperature, its efficiency is reduced
if the ambient temperature falls to below 15°C.
• Turn on the power and run the machine as per instructions below.
5.

Operation Instructions

Switch On / Switch Off The Unit
1. Connect the mains lead to socket.
2. Press Power button (A) once to turn on the unit. By default, it runs
on Manual Dehumidifying Mode.
3. Press Power button once again to turn off the unit.
90
MV-2562-2563-03-2023 eeese-aircare.com © All rights eeese air care aps
A