Cleaning And Care - Vitek VT-1286 B Die Betriebsanweisung

Vorschau ausblenden

Inhalt

Seite von 25

/ 25
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

Verfügbare Sprachen

Unplug the unit and wait until it cools down

–

before installing or removing the nozzle

brush (5).

Press the buttons (3) and remove the water

–

tank (4).

Open the water inlet (10) by pulling the plug

–

flag (9). Fill the water tank (4) with water.

Do not let water go over the MAX mark. Close

the water inlet (10) tightly.

Reinstall the water tank (4).

–

Attention!

Before removing the water tank (4) make

–

sure that the unit is unplugged.

Make sure that water drops do not get

–

onto the garment steamer body, onto the

power cord or the power plug.

Do not let water go over the «max» mark

–

when filling the water tank (4).

Do not fill the water tank (4) with sparkling

–

water, scent additives, vinegar, chemical

agents etc.

If you need to refill water during opera-

–

tion, switch the garment steamer off by

unplugging it.

Hang the clothes on a hanger.

–

Note:

Never steam clothes on a person, since the

–

steam is very hot. Use a hanger at all times.

For a stable steam delivery, keep the water

–

level above the minimal mark.

Do not direct steam flow onto metal elements.

–

Be careful when steaming clothes with metal

elements.

Insert the power plug into the mains socket,

–

press the on button (8). The pilot lamp

will start flashing. Wait until the pilot lamp

lights continuously.

Take the garment steamer with your hand and

–

hold it near the steam delivery button (2).

To begin steam delivery, press the button (2).

–

Note: You may lock the steam delivery button (2)

in pressed position for easy operation. To do this,

press the steam delivery button (2) and move the

lock to the lower position. To unlock the steam

delivery button (2), move the lock to the upper

position.

Slowly move the garment steamer along the

–

fabric in upward direction. Smooth out the

fabric with your other hand.

To stop steam delivery, release the button (2).

–

Notes:

Hold the garment steamer vertically and do

–

not turn it over.

VT-1286.indd 5

During the steamer operation, the upper part

–

of the unit body Becomes very hot. Be careful

and do not touch the hot parts of the unit body!

After steaming, the clothes should cool down

–

and dry up. This may take some time.

After the unit operation, unplug the garment

–

steamer and let it cool down.

To remove the attachments (5), pull the lock

–

(fig. 2).

Press the buttons (3) and remove the water

–

tank (4).

Open the water inlet (10) by pulling the plug

–

flag (9). Drain the remaining water from the

water tank (4) и close the water inlet (10)

tightly.

Reinstall the water tank (4).

–

Dry switch protection

If you accidentally switch the garment steamer

–

on when the water tank is empty or the water

level is below the minimal mark, the automatic

thermal switch will turn the garment steamer

off. If that happens, let the garment steamer

cool down for 15 minutes, then fill the water

tank with water and switch the unit on. It will

operate normally.

Automatic switch-off function

If you do not press the steam delivery button

–

for more than 8 minutes, the unit will be auto-

matically switched off and the pilot lamp

will start flashing. To resume the operation,

press the steam delivery button (2) once, wait

until the pilot lamp

(7)

again. Now the unit may be used normally.

(7)