Inhaltsverzeichnis
Werbung
SETUP MENU MAIN PAGE
GENERAL SETUP
SPEAKER SETUP
VIDEO SETUP
PREFERENCES
EXIT SETUP
10
AVR-1 Video Setup
Select the VIDEO SETUP
menu to set up your AVR-1 to
correctly match your TV.
NOTE:- This menu can only
be selected when the disc is
stopped.
VIDEO SETUP
NORMAL/PS
TV DISPLAY
TV TYPE
NORMAL/LB
RESOLUTION
WIDE/HDTV
VIDEO OUTPUT
MAIN PAGE
VIDEO SETUP
TV DISPLAY
TV TYPE
MULTI
RESOLUTION
NTSC
PAL
VIDEO OUTPUT
MAIN PAGE
VIDEO SETUP
TV DISPLAY
TV TYPE
SD INTERLACE
SD PROGRESSIVE
RESOLUTION
720P
VIDEO OUTPUT
1080I
MAIN PAGE
VIDEO SETUP
TV DISPLAY
TV TYPE
RESOLUTION
VIDEO OUTPUT
YPRPB
RGB
MAIN PAGE
TV DISPLAY enables you to choose the screen shape
of your TV. Choose NORMAL/PS (Pan & Scan) mode
to display a wide picture on a 4:3 size screen by cutting
the left and right sides of the picture. Choose
NORMAL/LB (Letterbox) to display the the full
widescreen picture on a 4:3 screen with bands at the
top and bottom. Choose WIDE/HDTV for a 16:9 wide-
screen TV.
TV TYPE enables you to select the video system
compatibility of your TV. Choose MULTI if your TV has
a dual PAL/NTSC video system. Choose NTSC if your
TV is a U.S. spec TV. Choose PAL to match TVs sold in
other markets. NOTE:- Do not change this setting
unless you are certain that the current setting is
incorrect, you may lose the TV picture.If you set the
incorrect setting and loose the picture press the stop
button for 5 seconds and the AVR-1 will reset and
return to standby. On power up the factory settings will
be restored.
RESOLUTION enables you to change the picture
quality to match your TV from Interlace - Progressive
720P - Interlace 1080. Set the highest quality
compatible with your TV. NOTE:- If you set the
incorrect setting and loose the picture press the stop
button for 5 seconds and the AVR-1 will reset and
return to standby. On power up the factory settings will
be restored. Depending on the way your screen's
internal scaling works the highest setting may not
necessatirly give the best results. Consult your
screen's manual to confirm the best setting.
Set the VIDEO OUTPUT to match the video
connection you made from the AVR-1 to your TV. If you
connected with a SCART cable, choose RGB. If you
connected with Component Video, choose YPRPB. If
you used a different video output connection, this
setting does not apply.
Werbung
Inhaltsverzeichnis
