Remote Punch Bass - Rockford Fosgate power 551x Einbau Und Betrieb

Passive crossovers are directly dependent upon the speaker's impedance and component value for
accuracy. When passive crossover components are used in multiple speaker systems, the crossover's
effect on the overall impedance should be taken into consideration along with the speaker's
impedance when determining amplifier loads.
CAUTION: These amplifiers are not recommended for impedance loads below 2Ω
!
6dB/Octave Low-Pass
6dB/Octave High-Pass
L = Low-Pass (Inductor)
C = High-Pass (Capacitor)
For more information, see your
Authorized Rockford Fosgate Dealer.

REMOTE PUNCH BASS

Mounting and installation
1. Find a location, either under the dash or
near the center console, that gives easy
access to the remote.
2. Using the screws supplied, install the
mounting clip with the tabs towards
the back.
3. Route the cable for the remote and
connect to both the remote and
amplifier.
4. Slip the remote onto the mounting clip
until it snaps into place.
5. Place the decal onto the remote and use
the nut to hold the decal in place. Do
not over tighten nut.
6. Install the knob onto the remote.
Downloaded from www.Manualslib.com
stereo and 4Ω bridged (mono).
L
C
manuals search engine
Speaker Impedance
Freq.
2 OHMS
Hertz
L C
80 4.1mH 1000µF 8.2mH
100 3.1mH 800µF 6.2mH
130 2.4mH 600µF 4.7mH
200 1.6mH 400µF 3.3mH
260 1.2mH 300µF 2.4mH
400 .8mH 200µF 1.6mH
600 .5mH 136µF 1.0mH
800 .41mH 100µF .82mH
1000 .31mH 78µF .62mH
1200 .25mH 66µF .51mH
1800 .16mH 44µF .33mH
4000 .08mH 20µF .16mH
6000 51mH 14µF .10mH
9000 34mH 9.5µF 68mH
12000 25mH 6.6µF 51mH
Mounting
Clip
Decal
Knob
Nut
I
NSTALLATION
4 OHMS 8 OHMS
L C L C
500µF 16mH 250µF
400µF 12mH 200µF
300µF 10mH 150µF
200µF 6.8mH 100µF
150µF 4.7mH 75µF
100µF 3.3mH 50µF
68µF 2.0mH 33µF
50µF 1.6mH 26µF
39µF 1.2mH 20µF
33µF 1.0mH 16µF
22µF .68mH 10µF
10µF .33mH 5µF
6.8µF .20mH 3.3µF
4.7µF .15mH 2.2µF
3.3µF 100mH 1.6µF
9