Cleaning
1. Wet the outer blade with water, and
2. Slide the power switch to the "O"
3. Turn off the power.
• Quick cleaning
4. Open the water inlet (see
5. Pour water through the
6. Wipe off water with a towel or
PB016214 - ER-GN300
Wet cleaning
apply some hand soap and some water
to the outer foil.
position, and let it foam for
approximately 10 seconds.
▼
To clean lightly dirty parts
page 13) and turn on the
power again.
• If the trimmings box is
removed, open the water
inlet after attaching the
trimmings box (see page 15).
water inlet at the " "
above the "
" mark, rinse
well and slide the power
switch to the "I" position.
▼
similar item, and let it dry naturally.
• It will dry faster with the blades and
the trimmings box removed (see
pages 13 and 15).
_(01GB)_06-20-18.indd 11
▼
To clean heavily dirty parts
• Complete cleaning
4. Slide the power switch to
the "I" position.
5. Remove the blades and
the trimmings box (see
pages 13 and 15) and rinse
under running water.
• Cover the drainage outlet of
washbasin to prevent the
inner blade from flowing
away.
▼
11
2018/6/20 10:53:52