Filling The Rinse Aid Reservoir - Hisense HI520D10X Handbuch

Filling The Rinse Aid Reservoir

1
Remove the rinse reservoir cap by
lifting up the handle .
3
Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is
designed to adjust the consumption by user. Follow the below steps.
1. Close the door,Switch on the
2. Within 60 seconds after step 1, press the Program button "
seconds, and then press the Delay Button to enter the set model, the rinse aid
indication blinks as 1Hz frequency.
3. Press the Program button"
habits ,the sets will change in the following sequence: D1->D2->D3->D4->D5->D1,
The higher the number, the more rinse aid the dishwasher uses.
4. Press the Power button to end the setup model.
Rinse aid level
D1
D2
D3
D4
D5
2
Pour the rinse aid into the dispenser,
being careful not to overfill.
appliance.
" to select the proper set according to your using
11
"more than 5
Selector position
rapid Light bright
90min Light bright
90min, rapid Light bright
glass Light bright
glass, rapid Light bright