Water Softener; Adjusting Salt Consumption - Hisense HI520D10X Handbuch

Water Softener

The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.

Adjusting salt consumption

The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Close the door,Switch on the
2. Within 60 seconds after step 1 Press the Program button
5 seconds,when the salt indicator blinks as 1Hz frequency means entering the
water softener settings.
3. Press the Program button "
environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6.
4. Press the Power button to end the setup model.
WATER HARDNESS
German German French French
dH dH
fH fH
0 - 5 0 - 9
6 - 11 10 - 20
12 - 17 21 - 30
18 - 22 31 - 40
23 - 34 41 - 60
35 - 55 61 - 98
° °
1
dH=1.25 Clarke=1.78 fH=0.178mmol/l
The manufactory setting: H3
Contact your local water board for information on the hardness of your water supply.
appliance.
，
"to select the proper set according to your local
British British
Mmol/l Mmol/l
Clarke Clarke
0 - 6 0 - 0.94
7 - 14 1.0 - 2.0
15 - 21 2.1 - 3.0
22 - 28 3.1 - 4.0
29 - 42 4.1 - 6.0
43 - 69 6.1 - 9.8
°
6
Water softener level Water softener level
H1-> Rapid Light bright
H2-> 90min Light bright
H3-> Rapid, 90min Light bright
H4-> glass Light bright
H5-> glass, Rapid Light bright
H6-> 90min, Glass Light bright
" "
for more than
Salt consumption Salt consumption
(gram/cycle) (gram/cycle)
0
9
12
20
30
60