Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
All manuals and user guides at all-guides.com
Technical Specification
Maximum load: 15kg. Size of flat panel TV: 254 - 635mm (10 - 25"). 15° vertical angle tilt adjustment.
CAUTION
This product is designed for installation on wood stud walls and concrete or brick walls.
Before installing make sure the supporting surface will support the combined load of the equipment and hardware. Never exceed the
maximum load capacity. This product is intended for indoor use only. Use of this product outdoors could lead to product failure and
personal injury. It is important to make sure the wall bracket is in the correct position so cables reach the correct sockets on the display.
When fitting the wall bracket make sure its at a height suitable for all people viewing the display. This is especially important for passive
3D which has a limited vertical viewing angle when used for 3D.
Keep television out of reach of young children. Do not exceed the maximum supported weight. Correct assembly is essential . It is
the responsibility of the installer to ensure that the wall structure is capable of supporting the screen and mount in a normal working
environment. Always check for hidden power cables and pipes before commencing work. Check the strength of the installation before
installing the screen. If you have any doubts concerning installation consult a qualified contractor.
Hardware List
A
B
C
D
E
F
G
Installation and Operation Instructions
Step 1: Use the wall plate as a template to drill four holes of 10mm diameter and 50mm depth in the concrete/brick wall. Then insert four
Plastic Wall Plugs (B) into the four holes. Make sure the holes don't have an over-sized diameter and vacuum them out after drilling. Avoid
drilling holes into the soft mortar between bricks and concrete blocks. Do not use hammer mode when drilling through the soft plaster
layer. It is important the wall plugs fit tightly and securely into the drilled holes.
NOTE: If mounting onto a stud wall, drill small holes of approximately 3mm diameter and 50mm depth into the wooden studs, using the
wall plate as a template.
B
Step 1
Step 2: Screw the 4 x hexagon-head screws (A) into the plastic wall plugs or directly into the wood, stopping when there is a 3–4mm gap
between the wall and the hexagon head.
Step 2
4
Werbung
Inhaltsverzeichnis
