Bresser 7009971 Bedienungsanleitung Seite 2

Thermo-Hygro-3CH-Sensor
433MHz
Art. Nr.: 7009971


Station Wait 5s
5 sec
MANUAL DOWNLOAD:
www.bresser.de/P7009971
Instruction Manual
EN
General Warning
DANGER!
This device contains electronic components which operate
via a power source (power supply and/or batteries). Do not
let children use the device while unattended. Only use the
device as described in the manual, otherwise you run the risk
of an electric shock.
Children should only use the device under adult supervision.
Keep packaging material, like plastic bags and rubber bands,
out of the reach of children, as they pose a choking hazard.
Keep batteries out of the reach of children. Make sure you
insert the batteries correctly. Empty or damaged batteries
could cause burns if they come into contact with the skin. If
necessary, wear adequate gloves for protection.
DANGER!
Do not expose the device to high temperatures. Use only
the recommended batteries. Do not short-circuit the device
or batteries, or throw them into a fi re. Excessive heat or
improper handling could trigger a short-circuit, a fi re or an
explosion!
NOTE!
Do not disassemble the device. In the event of a defect,
please contact your dealer. The dealer will contact the
Service Centre and can send the device in to be repaired,
if necessary.
Use only the recommended batteries. Always replace weak
or empty batteries with a new, complete set of batteries at
full capacity. Do not use batteries from different brands or
with different capacities. The batteries should be removed
from the unit if it has not been used for a long time.
NOTES ON CLEANING
Separate the device from the power supply or remove the
batteries before cleaning.
NOTE!
Only use a dry cloth to clean the exterior of the device. Do
not use any cleaning fl uid to avoid damaging the electronics.
SCOPE OF DELIVERY
Outdoor sensor, instruction manual, batteries required (not
included): 2 pcs. Batteries (1.5V, type AA)
Manual_7009971_High-Precision-Thermo-Hygro-Sensor_de-en_BRESSER_v012022a.indd 2 Manual_7009971_High-Precision-Thermo-Hygro-Sensor_de-en_BRESSER_v012022a.indd 2
FEATURES OF THE REMOTE UNIT
1
2

Sensor
1. LCD display
2. Transmission status LED
3. Wall mounting holder
4. [CHANNEL] slide switch
to assign the sensor to
Channel 1,2,3,4,5,6 or 7
LCD DISPLAY
1
2
3
GETTING STARTED
1. Remove the battery door.
2. Slide the [ CHANNEL ] slide switch to choose a channel.
3. Insert 2 x AA size batteries into the battery
compartment according to the polarity mark on the
battery compartment..
4. Close the battery door.
5. After inserting batteries, the transmission status LED
will light up 1 sec.
Note:
- Ensure to assign different channels of different sensors,
in case you need to pair more than one sensors.
- Once the channel is assigned to a Wireless Thermo-Hygro
sensor, you can only change it by removing the batteries
or resetting the unit.
- Avoid placing the sensor in direct sunlight, rain or snow.
PAIRING THE WIRELESS SENSORS WITH THE CONSOLE
The console will automatically search and connect to your
wireless sensor(s). Once your sensor(s) pair up successful,
the sensor(s) signal strength indication and weather
information will appear on your console display.
Note:
Every reading transmission, the symbol of signal
transmission, will fl ash at once.
TEMPERATURE / HUMIDITY FUNCTION
Use the [ °C / °F ] key to select the temperature display unit.
RESET THE SENSOR
In case of mal-function, press [ RESET ] button to reset the
sensor.
HOW TO PLACE THE SENSOR
- Choose a location on the exterior of the home where can
shield the sensor from direct sunlight or wet conditions
for an accurate reading.
- Hang it with the wall mount hole or place it directly on fl at
surface, and make sure the transmission is within 150
meters approx.
- Minimize obstructions such as doors, walls, furniture, etc.
DISPOSAL
Dispose of the packaging materials properly, according
to their type, such as paper or cardboard. Contact your
local waste-disposal service or environmental
authority for information on the proper disposal.
Do not dispose of electronic devices in the household
garbage! As per the Directive 2002/96/EC of the
European Parliament on waste electrical and
electronic equipment and its adaptation into German
law, used electronic devices must be collected separately and
recycled in an environmentally friendly manner.
3
4
5
6
7
5. [ RESET ] key
6. [ °C / °F ] key
7. Battery
compartment
1. Transmission signal indicator
2. Wireless sensor channel
4
3. Low battery indicator
4. Temperature reading
5
5. Humidity reading
In accordance with the regulations concerning
batteries and rechargeable batteries, disposing of
them in the normal household waste is explicitly
forbidden. Please make sure to dispose of your
used batteries as required by law — at a local collection point
or in the retail market. Disposal in domestic waste violates
the Battery Directive.
Batteries that contain toxins are marked with a sign and a
chemical symbol.
1
battery contains cadmium
2
battery contains mercury
3
battery contains lead
Cd¹ Hg² Pb³
EC DECLARATION OF CONFORMITY
Hereby, Bresser GmbH declares that the
equipment type with part number: 7009971 is in
compliance with Directive: 2014/53/EU. The full
text of the EU declaration of conformity is available at the
following internet address:
www.bresser.de/download/7009971/CE/7009971_CE.pdf
UKCA DECLARATION OF CONFORMITY
Bresser GmbH has issued a „Declaration of
Conformity" in accordance with applicable
guidelines and corresponding standards. The
full text of the UKCA declaration of conformity is
available at the following internet address: www.bresser.de/
download/7009971/UKCA/7009971_UKCA.pdf
Bresser UK Ltd. • Suite 3G, Eden House, Enterprise Way,
Edenbridge, Kent TN8 6Hf, Great Britain
Dimensions (W x H x D) 125 x 58 x 19 mm (4.9 x 2.2 x 0.7 in)
Weight 144g (with batteries)
2 x AA size 1.5V batteries (Lithium
Main power battery recommended for low
temperature environment)
Weather data Temperature and humidity
RF frequency 868Mhz (EU)
RF transmission range 150m (300feet) straight distance
5.1 ~ 60°C ± 0.4°C (41.2 ~ 140°F
Temperature Accuracy ± 0.7°F)
-20 ~ 5°C ± 1°C (-4 ~ 41°F ± 1.8°F)
1 ~ 20% RH ± 6.5% RH @ 25°C (77°F)
Humidity Accuracy 21 ~ 80% RH ± 3.5% RH @ 25°C (77°F)
81 ~ 99% RH ± 6.5% RH @ 25°C (77°F)
Number of channels 7 (CH1 ~ 7)
Transmission interval 60 seconds
Operating temperature range -20 ~ 60°C (-20 ~ 140°F)
Operating humidity range RH 1% to 99 %
SERVICE AND WARRANTY:
www.bresser.de/warranty_terms
Bresser GmbH
Gutenbergstr. 2
DE-46414 Rhede
Germany
Service:
Web: www.bresser.de/weather
E-Mail: service@bresser.de
Bresser UK Ltd.
Suite 3G, Eden House,
Enterprise Way, Edenbridge,
Kent TN8 6Hf, Great Britain
Besuchen Sie uns auf • Find us on:
14.01.2022 08:39:31 14.01.2022 08:39:31