Cleaning, Maintenance And Ordering Of Spare Parts; Ordering Spare Parts And Accessories; Disposal And Recycling - EINHELL TE-CD 18/45 3X-Li Originalbetriebsanleitung

6.14 Using the angle attachment (13) and
quick-change chuck (9) in combination
(Fig. 14)
To be able to drill holes in hard-to-reach places,
you can use the angle attachment (13) in combi-
nation with the quick-change chuck (9).
To do so, fi t the angle attachment (13) to the
equipment, as described in 6.12, and then fi t the
quick-change chuck (9) to the angle attachment
(13), as shown in Fig. 14.
You can then insert a suitable drill bit into the
quick-change chuck (9), as described in 6.9.
Check that the attachments are secure.
The drill chuck opening (a) must be large for the
drill bit to be inserted into it.
Tighten the quick-change chuck (9) and then
check that the drill bit is secure.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
Anl_TE_CD_18-45_3X-Li_SPK13.indb 21
GB

7.3 Ordering spare parts and accessories

Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com
Tip! For good results we
recommend high-quality ac-
cessories from
www.kwb.eu
welcome@kwb.eu

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempe-
rature is between 5 and 30 °C. Store the electric
tool in its original packaging.
- 21 -
!
23.08.2021 08:49:25