Operation - cecotec PUREAROMA 550 CONNECTED SAND Bedienungsanleitung

ENGLISH

3. OPERATION

The amount and intensity of steam can vary. This is not unusual and should not be
considered as a fault.
This can be affected by the water type, humidity, temperature and air currents.
The device will turn off automatically when it runs out of water.
Only use 100 % natural essential oils. If they contain any chemicals or impurities it may cause
damage to the product.
Place the product on a flat surface and remove the upper lid.
Fig. 5
Connect the adapter to the product's socket.
Fig. 6
Use a measuring cup to pour water or essential oils into the device. Do not use boiling water
and do not try to fill the device while it is operating. Then, add 2-3 drops of essential oil per
each 100 ml.
Fig. 7
Use the upper lid to close the unit again. The device must not be operated without the cover
on.
Fig. 8
Insert the power plug into the wall socket.
Buttons description
Power button
The device will buzz twice after being powered on and will start emitting steam.
Long press this button to turn the device off.
Intermittent mode works every 10 seconds.
Light button
Press the button once to turn on the product's light. The colour will change from one to
another automatically. There are 7 colours. Press this button 10 times to switch off this light.
Long press this button for 1 second to turn off the LED.
Steam button/Timer
Press it once for a medium level of steam. The device will buzz once.
Press it again for a higher level of steam. The device will buzz again.
Press it one more time to stop emitting steam.
Long press this button to switch to the Timer interface and setting an alarm.
Alarm button
Hold pressed the alarm button until the screen changes. Use the left and right buttons to set
the alarm. You can have three alarms on at the same time.
In order to cancel an alarm, hold it pressed and press "Cancel".
PUREAROMA 550 CONNECTED 27