2
4. Operation
Operating the perforated tool panel plates with
power supply
• Lay the cable properly behind the VIGOR
storage system.
• Insert the mains plug of the perforated tool
panel plates with power supply into a properly
fused socket.
• Connect the desired consumers. Make sure
that they are set to OFF to prevent them
from starting up by themselves.
• Pay attention to the nominal power / output
of the consumers so that the maximum load
is not exceeded.
• When unplugging from the socket, always
pull the plug, never the cable.
• Always make sure that the perforated tool
panel plate is correctly installed and firmly
seated in the VIGOR storage system!
• Only suitable for the lowest level.
5. Technical data
Cable length
Cable type / crosssection
Rated input voltage
Output voltage
Protection rating
Max. power
Weight V600005SP
Weight V6000015SP
Elektrische Energien können schwere Verletzungen verursachen!
VIGOR GmbH
[ +49 (0) 21 91 / 97 95 • \ +49 (0) 21 91 / 97 96 00 • ] info@vigor-equipment.com • ^ vigor-equipment.com
For your safety
V6000-05SP
V6000-015SP
2 m
H07RNF 3G2.5 mm²
220 – 250 V, 50/60 Hz,
Ampere: 16 A
220 – 250 V, 50/60 Hz,
Ampere: 16 A for safety plugs,
5 V 2.1 A for USB connections
IP20
3,500 W
4.5 kg
4.98 kg
Electrical energy may cause serious injuries!
• ; Am Langen Siepen 13-15 • 42857 Remscheid • GERMANY
Storage
• Store in a dry place. Protected from frost
and heat.
• In a place protected from dust and direct
sunlight
• Protect from dust with a cover if necessary
• Storage temperature: 25 °C up to +50 °C.
Included in delivery
V600005SP
• Perforated tool panel plate
with power supply
• Dimensions (W x H):
676 x 301 mm
V6000015SP
• Perforated tool panel plate
with power supply
• Dimensions (W x H):
861 x 301 mm
11