Faqs - Panasonic TX-55JX710E Bedienungsanleitung

FAQs

Before requesting service or assistance, please follow
these simple guides to solve the problem.
● For details, refer to [eHELP].
The TV does not switch on
● Check the mains lead is plugged into the TV and the
mains socket.
The TV goes into Standby mode
●
Auto power standby function is activated.
The remote control does not work or is intermittent
●
Are the batteries installed correctly?
●
Has the TV been switched on?
● The batteries may be running low. Replace them with
new ones.
● Point the remote control directly at the TV's remote
control signal receiver (within about 7 m and a 30
degree angle of the signal receiver).
●
Situate the TV away from sunshine or other sources
of bright light so they do not shine on the TV's remote
control signal receiver.
No image is displayed
● Check the TV is turned on.
●
Check the mains lead is plugged into the TV and the
mains socket.
●
Check the correct input mode is selected.
●
Check the setting in [Input Selection] to match the
signal being output by the external equipment.
●
Is [Contrast], [Brightness] or [Colour] in the Picture
Menu set to the minimum?
●
Check all required cables and connections are firmly
in place.
An unusual image is displayed
●
Turn the TV off with Mains power On / Off switch,
then turn it on again.
●
If the problem persists, initialise all settings.
[Factory Reset] in [Settings] > [Device
Preferences] > [About]
Parts of the TV become hot
●
Parts of the TV may become hot. These temperature
rises do not pose any problems in terms of
performance or quality.
When pushed with a finger, the display panel moves
slightly and makes a noise
●
There is a little gap around the panel to prevent
damage to the panel. This is not a malfunction.
About the inquiry
●
Please contact your local Panasonic dealer for
assistance.
If you make an inquiry from a place where this TV
is not present, we cannot answer about contents
that require visual confirmation for connection,
phenomenon, etc. of this TV itself.
11
English