Warm Start Of The Engine; Stopping The Device - Fuxtec FX-WP143 Original Bedienungsanleitung

Original Bedienungsanleitung FUXTEC FX-WP Serie_de_en_fr_ita_rev09
cord to fray or break. Always hold the starter handle firmly when the rope pulls back.
Never let the rope be thrown back from the pulled-out position. This could damage the
starter device.
Adjusting the pump capacity
After the engine has been started, the pumping capacity
can be adjusted via the throttle lever. Move the throttle
lever towards the device to increase the flow rate, move
it forward towards the pipe to decrease it (only for model
FX-WP152)
24.

Warm start of the engine

Place the device on a firm and flat surface.
1.
2. Move the engine stop switch down
3. Slide the choke to the "WARM START" position
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous, especially fast train will provide a vital spark and start
the engine
If the device does not start, please proceed again according to "Cold start of the device
25.

Stopping the device

Slide the throttle stick to the LOW position. Let the device return to idle. Push the engine
stop switch to the OFF position upwards until the device stops. If it does not control, pull
out the spark plug connector in an emergency. Never leave the device unattended while
it is running.
All manuals and user guides at all-guides.com
33
LOW
HIGH