Assembly Of The Device - Fuxtec FX-WP143 Original Bedienungsanleitung

All manuals and user guides at all-guides.com
Original Bedienungsanleitung FUXTEC FX-WP Serie_de_en_fr_ita_rev09
21.

Assembly of the device

Installation of the suction line
Use a standard hose and the hose connection with hose clamp (15;16), as supplied for
the pump. The suction line must be reinforced with a stiff wall or wire mesh. Do not use
a hose that is smaller than the suction mouth (11) of the pump. The suction line should
only be as long as necessary. The pumping performance is best when the pump is as
close to
the water level as possible, and the hoses are short.
Use a hose clamp to fix the hose connection to the suction line to avoid leakage air and
suction power loss. Make sure that the seal (14) of the hose connection is in good
condition.
Install the filter screen (17; supplied) at the other end of the suction line and fasten it
with a hose clamp. The filter screen ensures that the pump is not clogged or damaged
by foreign matter. Attach the hose connection to the suction mouth (11) of the pump.
Installation of the pressure line
Use a standard hose and hose connector with a hose clamp, as supplied for the pump.
It is best to use a short hose with a large diameter, reducing fluid friction and improving
pumping performance. A long or thin hose increases fluid friction and reduces pumping
capacity.
Tighten the hose clamp firmly to prevent the outlet hose from slipping under pressure.
Checking the filling level of the gasoline/oil mixture
Open the fuel cap and check the fuel level. Fill up with gasoline
if the fuel level is low.
WARNING
Gasoline is highly flammable and explosive. You could be burned or seriously injured
when handling gasoline. Switch off the engine and keep heat sources, sparks, and open
flames away. Only handle fuel outdoors. Wipe up spilled fuel immediately. Top up fuel in
a well-ventilated area before starting the engine. If the engine is hot, let it cool down.
Fill up with fuel carefully so that no gasoline overflows. Do not overfill the fuel tank. Fill
the tank to about 25mm below the rim to leave enough space for the gas to expand.
Depending on the
operating conditions, it may be necessary to reduce the fuel level. After refueling, close
the fuel filler cap firmly. Never refuel inside a building where petrol fumes can come into
contact with naked flames or sparks. Keep gasoline away from the ignition flames of
29