Quick Setup - Technoline WS6815 Bedienungsanleitung

OVERVIEW
A – Front view
A1: Indoor temperature
A3: Alarm ON
A5: RCC indicator
B- Top view
B1: SNOOZE / DIMMER button
C – Back view
C1: Battery door
C3: ALARM button
C5: DOWN/WAVE button
C7: Insert 1 x CR2032 battery inside the battery compartment
C8: DC socket
C10: AC/DC adapter
D- Outdoor temperature sensor
D1: LED indicator
D3: Channel 1,2,3 selector switch
ENVIRONMENTAL RECEPTION EFFECTS
The temperature station obtains the accurate time with wireless technology. Same as all wireless
devices, the reception is maybe affected by the following circumstances:

Long transmitting distance

Nearby mountains and valleys

Among tall buildings

Near freeway, railway, airports, high voltage cable etc.

Near construction site

Inside concrete buildings

Near electrical appliances (computers, TV's, etc)

Inside moving vehicles

Near metallic structures
Place the station at a location with optimal signal, i.e. close to a window and away from metal surfaces
or electrical appliances.

QUICK SETUP

Step 1 Keep the station and outdoor sensor next to each other. Slide open the battery cover at the
back of the outdoor sensor. Make sure the channel selector is set at position 1 (top position), then
insert 2 x AAA batteries (not included) into the outdoor sensor by observing the correct "+/-" polarity
signs inside the battery compartment. Replace the battery door.
Step 2 Insert the AC/DC adaptor to any 230V AC household outlet. Then insert the DC jack to the
back case of the station. Insert the stand to the bottom of the temperature station.
Step 3 Peel off the protective label on the front. The temperature station is ready to work for you.
The station will receive data signal from the outdoor sensor in few seconds. Then place the outdoor
A2: Time
A4: Outdoor temperature
A6: Stand
C2: UP button
C4: SET button
C6: RESET button
C9: Insert AC/DC adapter jack
D2: Holder
D4: Insert 2 x AAA batteries
EN2