Behringer ULTRA-DI DI600P Bedienungsanleitung Seite 3

4
ULTRA-DI DI600P
2.2 Taking a signal from a speaker output
+ (red/positive)
In
-30 dB!
- (black/negative)
Fig. 3: Connection to a power amp output
Sometimes, you want to take a signal directly from a speaker output,
even though just one speaker output is available. When you set the
INST/AMP switch to AMP, you can connect an amp output to your
mixing console (up to 3,000 Watts into 4 Ohms), without worrying
that it will be damaged due to overload!
◊ ◊
If you are using a tube amp, you must connect a speaker
or a similar load resistance to the parallel ¼" TS output.
◊ ◊
Before connecting to a loudspeaker connector,
please make sure that the GROUND LIFT switch is in
LIFT position (no ground connection). This prevents
accidental shorting of the amp output. Besides, the
tip of the input connector should be connected to the
speaker connector marked with red. The metal casing
of the DI600P should in no case have physical contact
to other equipment.
Out
Important Safety
Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Install in accordance with the manufacturer's instructions.
8) Only use attachments/accessories specified by the manufacturer.
9) Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been damaged in any way.
5
ULTRA-DI DI600P