Important Safety Instructions - Beper P301PIS100 Betriebsanleitung

EN
Hair Dryer and Volumizer Hot Air Brush Use instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.

Important safety instructions

Make sure to always unplug the appliance after every use.
Do not immerse or drop the appliance in water.
Do not store, use or install the appliance where there is a risk it might
fall into water (e.g. sink or bathtub).
If the appliance accidentally comes into contact with water o falls into
water, unplug it immediately. Do not attempt to retrieve the appliance
in the water.
Do not use the appliance if damaged or malfunctioning, or in case the
power cable and/or the plug have been damaged.
Do not leave the appliance operating unattended.
Do not insert any foreign object inside the openings and vent holes.
Make sure all openings and vent holes are free from obstruction du-
ring use, and that are always free from dust and dirt.
This appliance cannot be used by children, or persons with reduced
physical, sensitive or intellectual capabilities, or with lack of expe-
rience and knowledge, without supervision or if they are not given
instructions and warnings on the correct and safe use of the device
and the potential risks related to its use.
Do not use this device in a bathtub, shower, or water-filled reservoir
When the hairdryer is used in a bathroom, unplug it after use since
the proximity of water presents a hazard even when the hairdryer is
switched off.
For additional protection, the installation of a residual current device
(RCD) having a rated residual operating current not exceeding 30 mA
is advisable in the electrical circuit supplying the bathroom. Ask your
installer for advice.
7