Troubleshooting; Error Correction - Deltafox DP-EWC 2415 Originalbetriebsanleitung

Troubleshooting

Always unplug the shredder before working on it. Risk of electric shock!
Problems
Device doesn't
start
Grinding tool
does not move
although the en-
gine is runningt
Engine is slower
and stops
Grinding disc
does not rotate
smoothly, abnor-
mal noises can
be heard
Possible Cause
Mains voltage missing
Main circuit breaker is
tripped
On/off switch (
be defective
Engine faulty
Hexagon bolt (
Workpiece, remaining work-
pieces block drive
Device is overloaded
through workpiece
Hexagon bolt (
Cutting discs are defective

Error correction

Check the socket, mains cable,
line, mains plug, repairs to be car-
ried out by qualified electrician
if necessary, check main circuit
breaker.
3) may
Repair by Customer Care
9) loose Tighten the hexagon bolt (see "In-
stalling/changing the cutting discs")
Remove blockages
Reduce pressure on cutting tool
Workpiece unsuitable
9) loose Tighten the hexagon bolt (see "In-
stalling/changing the cutting discs")
Change cutting discs
GB
81