Outwell LEONIS LUX Bedienungsanleitung

LEONIS LUX
MODEL: 650857 ( CREAM WHITE )
MODEL: 650858 ( CREAM WHITE – UK )
MODEL: 650859 ( LIME GREEN )
MODEL: 650860 ( LIME GREEN – UK )
1. BUTTON
7. LAMP BODY
2. LAMPSHADE
( EXTENDED )
4. ADJUSTABLE
HANGING POINT
5. AC/DC ADAPTER
3. LAMPSHADE ( COLLAPSED )
6. EDGE OF
LAMPSHADE
UK: INSTRUCTION MANUAL
Light modes:
• Press the button (1.) to switch on / off
the light.
• Press and hold the button to dim the
light. The light can be dimmed step-
less to any setting between maximum
and minimum light output.
Use of the lamp:
• Lamp is powered by 100-240V AC.
• To extend lantern lampshade, grab
the edge of the lampshade (6.) and
push the body out from the inside, do
not pull on the cord.
• To collapse the lampshade, reverse
the above.
• Hang lamp from the hanging point,
adjust height as needed by gently
moving the cord through the adjuster.
• For indoor use only.
• Lamp can be cleaned with
a damp rag.
• Do not use corrosive
liquids to clean the lamp.
• Do not stare into the light source.
Light source: LED
This product contains a
light source of energy
efficiency class E.
Light source and control
gear are not replaceable.
This would introduce weak
points in the construction, that could
reduce the lifetime of the product.
Instruction for removal of light source
and control gear by market surveil-
lance authorities:
1) Remove lamp lens by using a flat-
head screwdriver to open the four tabs.
2) Unscrew 2 pcs screws holding PCB
with LEDs in place.
3) Cut needed wires to remove the
required components for testing.
Instruction for disassembly of lamp
for disposal of components
when lamp has reached the
end of its usable life:
- See steps 1-2 above
3) Cut wires and remove screws
to allow removal of electronics on
circuit board. Dispose of electronics
according to local regulations.
4) Dispose of remaining components
according to local regulations.
Technical data:
Input (AC/DC adaptor):
100-240V , 0.3A
Output (AC/DC adapter):
5V, , 2A
Input (Lamp unit): 5V
Class 2 appliance