Hengstler tico 77 Series Benutzerhandbuch Seite 47

6 Configuring with the programming assistant
No file found
USB
Neither a global nor single configuration file has been found.
noFILE
The configuration process has been aborted. The display re-
turns to standard view after a couple of seconds.
Global configuration file found
USB
A global configuration file has been found. Press "E" to con-
GLObAL
firm and start the configuration process. Press any other key to
abort the process. If no keys are pressed within 10 seconds, the
process is, again, automatically aborted.
Single configuration file found
USB
A single configuration file has been found. Press "E" to confirm
SInGLE
and start the configuration process. Press any other key to
abort the process. If no keys are pressed within 10 seconds, the
process is, again, automatically aborted.
Counter is being configured
USB
The counter is configured using the file it has found.
COnFIG
No configuration command executed
USB
A configuration file has been found and the configuration
no CFG
started, but no command has been executed. Very probably,
the file does not contain any configuration commands (com-
ments not excluded).
Configuration complete
USB
The configuration was completed without error. In order to re-
donE
configure the counter, remove the USB drive and insert again.
Error 1: Drive was removed before configuration started
USB
A configuration file was found, but the interface could no lon-
E1
ger detect a drive when the configuration process was started
manually. The process is aborted and a restart prevented since
no configuration has taken place. The display returns to stan-
dard view after a couple of seconds.
17