Chapter -7: Tips For Saving Energy; Chapter -8: Technical Data - Sharp SJ-TA30ITXIF-EU Bedienungsanleitung

CHAPTER -6: TROUBLESHOOTING
Bubbling noise and splash: This noise is caused by the flow of the refrigerant in the tubes of the system.
Water flow noise: Normal flow noise of water flowing to the evaporation container during defrosting. This noise
can be heard during defrosting.
Air blowing noise (normal fan noise): This noise can be heard in No-Frost fridge during normal operation of the
system due to the circulation of air.
If humidity builds up inside the fridge;
• Has the food been properly packaged? Have the containers been well dried before they were put into the
refrigerator?
• Are the doors of the refrigerator opened very frequently? When the door is opened, the humidity in the ambient
air enters the refrigerator. Especially if the humidity rate in the room is too high, the more frequently the door is
opened the faster will be the humidification.
• It is normal to have water drops form on the back wall following the automatic defrosting process. (In Static
Models)
If the doors are not opened and closed properly;
• Do the food packages prevent closing of the door?
• Are the door compartments, shelves and drawers placed properly?
• Are door gaskets broken or torn?
• Is your fridge standing on a level surface?
If the edges of fridge cabinet that the door joint contact are warm;
Especially in summer (hot weather), the surfaces that the joint contact may get warmer during the operation of the
compressor; this is normal.
IMPORTANT NOTES:
• The compressor protection thermal fuse will cut out after sudden power breakdowns or after unplugging the
appliance, because the gas in the cooling system is not stabilised. This is quite normal, and the fridge will
restart after 4 or 5 minutes.
• The cooling unit of your refrigerator is hidden in the rear wall. Therefore, water droplets or ice may occur on the
rear surface of your fridge due to the operation of the compressor in specified intervals. This is normal. There
is no need to start manuel defrost unless the ice formation is excessive.
• Unplug your fridge if you will not be using it for an extended period of time (e.g. during summer holidays). Clean
your fridge according to chapter on cleaning and leave the door open to keep humidity and odours from forming.
• The appliance you have purchased is designed for home type use and can be used only at home and for the
stated purposes. It is not suitable for commercial or use. If the consumer use the appliance in a way that does
not comply with these features, we emphasise that the producer and the dealer shall not be responsible for any
repair and failure within the guarantee period.
• If the problem persists after you have followed all the instructions above, please consult an authorised service
provider.

CHAPTER -7: TIPS FOR SAVING ENERGY

1. Always allow foodstuffs to cool before storing in the appliance.
2. Thaw food in the fridge compartment; this helps save energy.

CHAPTER -8: TECHNICAL DATA

The technical information is situated in the rating plate on the internal side of the appliance and on the energy label.
The QR code on the energy label supplied with the appliance provides a web link to the information related to the
performance of the appliance in the EU EPREL database.
Keep the energy label for reference together with the user manual and all other documents provided with this appliance.
It is also possible to find the same information in EPREL using the link https://eprel.ec.europa.eu and the model name
and product number that you find on the rating plate of the appliance.
See the link www.theenergylabel.eu for detailed information about the energy label.
EN -12-