Setup Manual - RDM Isolator
Safety instructions
Only use the device in compliance with the environmental conditions
i
specified and watch the technical characteristics. Otherwise the unit
may be damaged or malfunction will happen.
Only use original e:cue accessories to power the RDM Isolator Other
i
power supplies can damage the unit.
To prevent the device from overheating, only operate it in well-ventilat-
i
ed environment. Ventilation may not be obstructed. Do not install next
to heat emitting sources or in a place subject to direct sunlight.
Device components inside the system can reach high temperatures!
To avoid burns, allow the unit to cool for at least 20 minutes before
unmount or repair.
Installation and maintenance of this product must be performed by
i
individuals who are knowledgeable about the procedures, precautions
and hazards associated with the product.
6