TFA VIEW SHOW Bedienungsanleitung Seite 22

6.3.5 Display area: MOON PHASE (Fig.1-E)
Standard function (without online connection) / MOON PHASE
In the normal display, the current moon phase in 12 steps is shown here.
y
With online connection / FORECAST
y When forecast values are received for this display area while the online connection is active, a small radio symbol
displayed next to FORECAST (on the right).
The weather symbol displayed is then a forecast for the next 12 hours prepared by professional meteorologists.
y
The projection alarm clock has 12 different weather symbols
y
Sunny slightly cloudy
Sleet fog
In the upper right corner, the probability of rain in percent is displayed next to the weather symbol.
y
The forecast refers to the location (region/zip code) that was saved during the installation of the device via the app.
y
6.4 Alarm and NAP function
6.4.1 Alarm function
Press and hold the ALARM button (Fig.2-A) in normal mode for 3 seconds to set the alarm function.
y
The hour digit flashes on the display. Press the + or - (Fig.2-F+G) button to adjust the hours.
y
Confirm the setting with the SET button (Fig.2-H).
y
The minutes digits flashes on the display. Press the + or - button to adjust the minutes.
y
Confirm the setting with the SET button.
y
y 10 minutes (default) or the last adjusted snooze interval flashes. Press the + or - button to set the snooze interval
(5 to 120 minutes).
y Confirm the setting with the SET button and you will return to normal mode.
After setting an alarm time, the alarm function is automatically activated.
y
To activate or deactivate the alarm function, press the ALARM button in normal mode. The set alarm time is displayed for 3 seconds and
y
the alarm symbol appears (alarm activated) or disappears (alarm deactivated) next to the alarm time.
Back in the normal display, an alarm symbol
y
is activated.
When the adjusted alarm time is reached, the alarm rings.
y
Press any button (except SNOOZE/LIGHT) and the alarm will stop.
y
If the alarm is not stopped manually, the ascending alarm tone automatically turns off after two minutes and it will be reactivated at the
y
same set time on the following day.
When the alarm rings, press the SNOOZE/LIGHT button and the snooze function is activated.
y
y SNOOZE appears in the upper display next to the time and the alarm will be interrupted for the set time. The remaining duration of the
interruption is displayed and counts backwards.
y Press any button (except SNOOZE/LIGHT) and the snooze function will stop.
cloudy rainy
isolated rain low snowfall
is permanently displayed in the time area (above the seconds) when the alarm
22
is permanently
thunderstorm heavy snowfall
frost stormy