Step 10: Fans - Connecting Cables - EK Nucleus AIO CR360 Vision D-RGB Installationsanleitung

USB Connector
USB Header
Female Connector
Male Connector
Female Connector
D-RGB Connector
Fan Connector
Fan
Connector
STEP C:
In the case of the EK-Nucleus Vision versions,
plug the 4-pin USB connector from the pump
to the USB HEADER on the motherboard.
STEP 10: FANS – CONNECTING
CABLES
STEP A:
Connect the 4-pin fan connector from the
extension cable directly to the CPU fan header
on the motherboard. Always use CPU fan
header when possible.
D-RGB Header
RGB Header
Female Connector
Male Connector
Female Male
Connector Connector
- 8 -
STEP B:
Plug the 3-pin D-RGB connector from the extension
cable to the D-RGB header on the motherboard.
Please ensure that the arrow indicated on
the connector is plugged into the +5V line
as indicated on your motherboard. If you
put LED Diode to the 12V RGB HEADER
you can damage the LEDs.
Connector is the same on D-RGB and RGB
versions, but D-RGB version has 3 cables
from connector to PCB; RGB version has
4 cables. If you connect D-RGB led to
ordinary RGB header you can damage
your motherboard or LED strip.
STEP C:
Connect the female connector from the
extension cable to the male connector from
the fi rst fan in line.
Be careful to turn the micro-fi t connector
correctly.
STEP D:
In the case of the EK-Nucleus AIO CR240
D-RGB or EK-Nucleus AIO CR360 D-RGB
version, connect the second and third fan in
series with the "daisy-chain".
Be careful to turn the connector correctly.