Step 8: Installing The Assembly Of Fans And Radiator Into A Pc Case; Step 9: Pump - Connecting Cables - EK Nucleus AIO CR360 Vision D-RGB Installationsanleitung

EK-AIO Nucleus 240
UNC 6-32 x 6 mm
(8x)
EK-AIO Nucleus 360
UNC 6-32 x 6 mm
(12x)
STEP 8: INSTALLING THE ASSEMBLY
OF FANS AND RADIATOR INTO A PC
CASE
Attach the assembly of radiator and the fan(s)
to the PC case with the UNC 6-32 x 6mm
screws.
Radiator on top (recommended)
Vertical placement of the radiator with
tubing at the bottom (recommended)
USB Connector
4-pin
PWM
D-RGB Connector
- 7 -
Avoid vertical placement of the radiator
with tubing at the top
Avoid radiator at the bottom
STEP 9: PUMP – CONNECTING
CABLES
STEP A:
Plug the 4-pin PWM connector from the pump
to the motherboard.
STEP B:
Plug the 3-pin connector from the pump D-RGB LED
light to the D-RGB HEADER on the motherboard.
The LED will work if the pin layout on the header is as
follows: +5V, Digital, empty, Ground. Alternatively, with
some motherboards you can use a VDG connector
instead of a D-RGB to connect the LED.
Please ensure that the arrow indicated on
the connector is plugged into the +5V line
as indicated on your motherboard. If you
put LED Diode to the 12V RGB HEADER
you can damage the LEDs.
Connector is the same on D-RGB and RGB
versions, but D-RGB version has 3 cables
from connector to PCB; RGB version has
4 cables. If you connect D-RGB led to
ordinary RGB header you can damage
your motherboard or LED strip.