Step 8: Pump - Connecting Cables (Amd); Step 9: Fans - Connecting Cables (Amd) - EK Nucleus AIO CR360 Vision D-RGB Installationsanleitung

USB Connector
4-pin
PWM
D-RGB Connector
Avoid vertical placement of the radiator
with tubing at the top
Avoid radiator at the bottom
STEP 8: PUMP – CONNECTING
CABLES (AMD)
STEP A:
Plug the 4-pin PWM connector from the pump
to the motherboard.
STEP B:
Plug the 3-pin connector from the pump D-RGB LED
light to the D-RGB HEADER on the motherboard.
The LED will work if the pin layout on the header is as
follows: +5V, Digital, empty, Ground. Alternatively, with
some motherboards you can use a VDG connector
instead of a D-RGB to connect the LED.
Please ensure that the arrow indicated on
the connector is plugged into the +5V line
as indicated on your motherboard. If you
put LED Diode to the 12V RGB HEADER
you can damage the LEDs.
Connector is the same on D-RGB and RGB
versions, but D-RGB version has 3 cables
from connector to PCB; RGB version has
4 cables. If you connect D-RGB led to
ordinary RGB header you can damage
your motherboard or LED strip.
USB Connector
USB Header
Female Connector
Male Connector
Female Connector
D-RGB Connector
Fan Connector
Fan
Connector
- 11 -
STEP C:
In the case of the EK-Nucleus Vision versions,
plug the 4-pin USB connector from the pump
to the USB HEADER on the motherboard.
STEP 9: FANS – CONNECTING
CABLES (AMD)
STEP A:
Connect the 4-pin FAN connector from the
extension cable directly to the CPU fan header
on the motherboard. Always use a CPU fan
header when possible.