Installation - BOMANN DU 772 IX Bedienungsanleitung, Garantie

Installation

Installation Installation Installation
There must be a safety distance between the hot-
plate of the cooking pot on the hob and the bottom
part of the cooker hood:
The distance must be between 65 5 5 5 – – – – 75 The distance must be between 6 The distance must be between 6 The distance must be between 6
appliances, the distance must be at least 65 cm. appliances, the distance must be at least 65 cm. If appliances, the distance must be at least 65 cm. appliances, the distance must be at least 65 cm.
the installation instructions for the gas cooker specify
a greater distance, this distance must be taken into
consideration.
Selecting the fume outlet Selecting the fume outlet
Selecting the fume outlet Selecting the fume outlet
You can operate the cooker hood in two modes:
Extraction mode Extraction mode Extraction mode Extraction mode
WARNING: WARNING: WARNING: WARNING:
• The extracted air may not be vented into a flue
which is used for the waste gas from appliances
which are powered by gas or other fuels.
• When venting the extracted air, comply with the
regulations of the relevant local authorities.
The hood has an upper air outlet to vent cooking
odours to the outside.
The extracted air is normally vented verti-
cally. The extracted air can vented
through the wall units and the loft floor to
the roof ridge.
If there is a conduit under the wall units,
the extraction duct can be routed so that
the extracted air can be vented horizon-
tally through the wall.
Recirculation mode Recirculation mode Recirculation mode Recirculation mode
If you do not have a direct extraction vent to the out-
side; the hood can also work in recirculation mode
(i.e. without an extraction vent to the outside; the
filtered air is released back into the room). In this
case, an activated carbon filter as described under
"Installing the activated carbon filter for recirculation
mode", must be used.
All manuals and user guides at all-guides.com
Activated carbon filter are not supplied. You can or-
der the carbon filter from your dealer or in our online
accessories shop,
the reference number found under "Technical Data".
75 75 cm. For 75 cm. For gas cm. For cm. For gas gas gas
Assembly Assembly
Assembly Assembly
• When assembling or inserting the extraction filter
• Failure to use the mounting fixtures may lead to a
• Before mounting, check that the ceiling has suffi-
• When drilling the holes in the ceiling always make
• Make sure that the ventilation slots are clear of
• When installing, ask another person to assist.
• Wear protective gloves to prevent injuries from
• Determine the position of the cooker hood central-
• Fix the hanging board with 12 x
• With 8 x screws M4*10 fix the iron
16
www.bomann.de www.bomann.de www.bomann.de www.bomann.de. To order, use
WARNING: WARNING: WARNING: WARNING:
as well as the carbon filter, the appliance must not
be connected to the mains.
risk of electric shock risk of electric shock. risk of electric shock risk of electric shock
CAUTION: : : : CAUTION CAUTION CAUTION
cient load capacity to bear the cooker hood.
sure that no existing electrical cables or other ob-
jects are damaged.
obstacles and are not covered.
NOTE NOTE NOTE: : : : Recomm NOTE Recommendations for preparation work Recomm Recomm endations for preparation work endations for preparation work endations for preparation work
any sharp edges.
ly above the hob in conformance with the speci-
fied safety distances.
screws ST6*40 on the ceiling.
corner on the hanging board.
Calculate the required length of the
iron corner, and use 16 x screws
M4*10 to connect the iron corner to
each other (overlap length not less
than 10 cm).