Technical Information - AEG FAVORIT 45020 VI Benutzerinformation

36 www.aeg.com
Problem
The appliance does
not drain the water.
After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes show, contact the
Service.
IF THE WASHING AND
DRYING RESULTS ARE NOT
SATISFACTORY
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector
to a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature drying
phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tab-
lets can be the cause. Try a different

TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
Water supply
All manuals and user guides at all-guides.com
Possible cause
The sink spigot is clogged.
The water drain hose has a
kink or a bend.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
1)
Cold water or hot water
Possible solution
Clean the sink spigot.
Make sure that the position
of the hose is correct.
brand or activate the rinse aid dispens-
er and use rinse aid together with the
combi detergent tablets.
Refer to 'HINTS AND TIPS' for
other possible causes.
Activating the rinse aid
dispenser with the multitab
function activated
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
3. Press and hold function buttons (B)
and (C) at the same time until the indi-
cators of function buttons (A), (B) and
(C) flash.
4. Press function button (B).
• The indicators of function buttons
(A) and (C) go off.
• The indicator of function button (B)
continues to flash.
• The end indicator is off.
5. Press function button (B) to change
the setting.
• The end indicator comes on. The
rinse aid dispenser is active.
6. Deactivate the appliance to confirm.
7. Adjust the released quantity of rinse
aid.
8. Fill the rinse aid dispenser.
596 / 818 - 898 / 550
(0.5 / 0.05 ) / (8 / 0.8 )
2)
220-240 V
50 Hz
max. 60 °C