Nacon GC-200WL Bedienungsanleitung Seite 4

EN /
I Charging your controller
The NACON GC-200WL wireless controller is equipped with an internal 700mAh battery. To
charge this battery use the supplied Micro-USB cable and connect it to the socket on the top of
the GC-200WL. Then plug it into one of your free USB ports on your PC. The 4 LEDs will light up
to indicate that the charging process has started and will also show the charging level of the
battery.
Remark: Please note that the controller can't be used during the charging process.
I First-time connection with the PC
The NACON GC-200WL is a so-called Plug´n´Play device. This means that the necessary driver
software should be installed automatically if you connect it to your computer for the first time.
Here are the steps in detail:
• Make sure your that the battery of your GC-200WL controller is sufficiently charged.
• Turn on your computer, wait for it to boot and log in to your Windows® desktop.
• Look for an unused USB slot on your PC and plug in the USB dongle of your NACON GC-200WL
controller.
• Windows® will detect the new device and after a few seconds it will start the installation
process for the appropriate drivers. This is shown by a small icon in the taskbar.
• The installation might take a while depending on the speed of your system. Once the
installation is complete, you will be presented with the according message. You can now use
your GC-200WL.
• On your GC200WL, you can press the Home button for 6 seconds to turn on the controller and
let it connect to the dongle.
I Dongle compartment
When not in use, the dongle of your NACON GC-200WL wireless controller can be stored in the
socket on the bottom of the controller to prevent it from loss.
Remark: The dongle compartment is for storage only and does not have any electronic function.
I D/X switch
There are different ways for modern computer games to communicate with your controller and
vice versa. Your GC-200WL supports the two most commonly used ones: Direct Input 8 and
X-Input.
Sometimes a game only supports one of these two protocols. Since both can´t be run
simultaneously, your GC-200WL features the D/X switch (10) to select one of these two
protocols, to make sure it works with all games.
Remark: After changing the protocol, the controller needs some short time to switch.