Instructions For Use; Plug-And-Play-Betrieb - Telestar EC 311 S Montageanleitung

8 Temperature sensor 1 is
overheated
9 Temperature sensor 2 is
overheated
10 CP Fault
11 Emergency stop protection
Table 2: Introduction of failures shown by indicator light
Red light flashing fault code introduction: red light flashing indicates that there is a fault in the system
and the number of flashing times corresponds to the fault code.
For example, if the fault code 5 appears, the red light will flash 5 times.
When there are multiple faults, the device only displays one fault code.
When short-circuit protection fault and leakage fault appear, the device will not continue to charge.
These faults cannot be recovered until the charging plug is disconnected and then reconnected while
other faults do not need to disconnect and then reconnect the charging plug because the charging
process will automatically resume after the faults are recovered.
9. INSTRUCTION FOR USE
Choose different starting methods according to the specifications used:
TELESTAR EC 311 S:
Connect one end of the charging gun to the charging socket on charging station and the other end to
the vehicle charging port. When the indicator light on charging station turns green, it indicates that the
charging station is connected with the car and is ready to start the charging process.
TELESTAR EC 311 S6:
Insert the charging gun into the car charging port. When the indicator light of the charging station
turns green, it indicates that the charging station is connected with the car and is ready to start the
charging process.

9.1. PLUG-AND-PLAY-BETRIEB

TELESTAR EC 311 S / EC 311 S6
The red light flashes 8 times, and the rest are off
The red light flashes 9 times, and the rest are off
The red light flashes 10 times, and the rest are off
The red light flashes 11 times, and the rest are off
E
21