Installation Guide; With The Telestar Ec 311 S; With The Telestar Ec 311 S6; Step 2: Cabling (Input Power Interface Of The Device) - Telestar EC 311 S Montageanleitung

6. INSTALLATION GUIDE

First start with the installation and cabling of the charging station and, in the second step, install the
cable in the meter cabinet.
Please note that there must be a corresponding protection in the meter cabinet. Ask your electrician
about this.
6.1 STEP 1: INSTALLATION OF WALL MOUNTING PLATE

6.1.1 With the TELESTAR EC 311 S

As shown in Figure 3, drill 4 mounting holes with a diameter of 5 mm and a depth of 50 mm at
the corresponding height at a distance of 140mm x 80mm and fasten the mounting plate with
the dowels and screws included in the packaging (M5 * 30) on the wall.
Figure 3: Installation drawing of TELESTAR EC 311 S charging station mounting plate

6.1.2 With the TELESTAR EC 311 S6

As shown in Figure 4, drill 6 mounting holes with a diameter of 5 mm and a depth of 50 mm at
the appropriate height and attach the mounting plate to the wall using the dowels and screws
(M5 * 30) included in the packaging.
Figure 4: Installation drawing of TELESTAR EC 311 S6 charging station mounting plate

6.2 STEP 2: CABLING (INPUT POWER INTERFACE OF THE DEVICE)

1. Remove the cover of the protection box (Figure 8)
2. Insert the input cable and clamp the cable accordingly
It is recommended to use a copper cable with a rubber core (NYM-J) as the input cable, route
the cable through the cable opening of the charging station, then the neutral conductor, the
live conductors (L1 / L2 / L3) and attach the PE conductor to the corresponding terminals and
finally fix the cable
TELESTAR EC 311 S / EC 311 S6
E
17