Suction Hose - Metabo SPA 1702 W Originalbetriebsanleitung

ENGLISH
6.4 Filter, filter retaining clip and dust bag
Screw M6 hexagon nuts into the filter retaining
clip (2) halfway up the thread. Push on washers
6,4 and insert filter retaining clip (2) into the
holes provided on the extractor (6).
Secure washer 6,4, stranded earth wire and
serrated lock washer to the filter retaining clip
(2) with M6 hexagon nuts, as shown in the
illustration. Tighten M6 hexagon nuts.
Screw on washer 6,4 with M6 hexagon nut on
the other side of the filter retaining clip (2) and
tighten.
Push the filter (1) over the filter retaining clip (2).
Push tension band over the filter (1). Push the
filter (1) with tension band over the connector
on the extractor assembly (6). Make sure that
the filter (1) is over the extractor connector (6)
all the way round and is positioned under the
tension band. Secure the tension band with a
screwdriver.
16 16
6
Push tension band (9) over the dust bag (11).
Push tension band with bag over the connector
on the underside of the extractor assembly (6).
Make sure that the dust bag (11) is over the
extractor connector (6) all the way round, and is
positioned under the tension band. Align
tension band so that it is positioned on the foam
strip all the way round. Secure the tension band
(9) by folding over the locking lever.

6.5 Suction hose

Push the hose clamp (8) over the suction hose
(10). Push the suction hose (10) onto the small
connector on the extractor assembly (6). Make
sure that the suction hose (10) is positioned
correctly all the way round. Secure the suction
hose with the hose clamp (8).
Автотовары «130»
9
9
11