TFA RIPLE TIME XL Bedienungsanleitung Seite 8

TFA_No. 38.2023_Anl_10_21
TRIPLE TIME XL – Digital Triple Timer
4.2 Display
Clock-mode (Fig. 1)
J: Upper display: Time
K: Middle display: 1/100 seconds (stopwatch)
L: Lower display: Hours/minutes/seconds (stopwatch)
TIMER-mode (Fig. 2)
M: Upper display: TIMER 1
N: Middle display: TIMER 2
O: Lower display: TIMER 3
4.3 Housing (Fig. 3)
P: Stand (fold out)
Q: Wall mount hole
R: RESET button
S: Magnet
T: Battery compartment
5. Getting started
• Open the battery compartment and remove the insulation strip.
• A short beep will sound and all LCD segments will light up for about 2 seconds.
• The unit is now ready to use.
6. Operation
• Press CLOCK/TIMER button to toggle between CLOCK-mode or TIMER-mode.
• Press and hold HR button or MIN/12/24 HR button or SEC button, you will enter fast mode.
• All successful settings will be confirmed by an acoustical signal.
7. Time
• Press and hold CLOCK/TIMER button in CLOCK-mode for 3 seconds.
• In the upper display the hours, minutes and seconds indication flashes.
14
29.10.2021 15:29 Uhr Seite 8
TRIPLE TIME XL – Digital Triple Timer
• Press HR button to set the hours, press MIN/12/24 HR button to set the minutes and
press SEC button to set the seconds.
• Confirm with CLOCK/TIMER button.
• Press MIN/12/24 HR button to choose 12 HR (AM or PM appears on the display) or 24
HR system.
8. Stopwatch
• Press ST/SP/MEMORY button in CLOCK-mode.
• In the middle display the 1/100 seconds will be counted.
• Hours, minutes and seconds appear in the lower display.
• Use ST/SP/MEMORY button to stop and restart the counting.
• Press CLEAR button to reset the display.
9. Count Down Timer
• In TIMER mode TIMER 1 appears in the upper, TIMER 2 in the middle and TIMER 3 in the
lower display.
• Press and hold T1 or T2 or T3 to select a TIMER.
• A short beep will sound and the selected TIMER is flashing.
• Press HR button to set the hours, press MIN/12/24 HR button to set the minutes and
press SEC button to set the seconds.
• Press the respective T1 or T2 or T3 button to confirm the desired setting.
• Press T1 or T2 or T3 button to start the count-down of the respective TIMER.
• Press T1 or T2 or T3 button again to stop/restart the counting of the respective TIMER.
• For simultaneous operation of all three TIMERS set the desired time for TIMER 1, TIMER
2, TIMER 3.
• Press ST/SP/MEMORY button to start, stop and restart the countdown of TIMER 1,
TIMER 2, TIMER 3 at the same time.
• When the TIMER counts down to 00:00:00, a beeping alarm (1 min.) will sound, the dis-
play flashes and TIME'S UP appears.
• Now the TIMER will start to count up the elapsed time until it is stopped by pressing
ST/SP/MEMORY button or the respective TIMER button (T1, T2, T3).
• To clear the reading (TIMER 1, TIMER 2, TIMER 3) use CLEAR button.
15