Connection To The Mains Supply - Werock Rocktab S100 Bedienungsanleitung

Hint: Before connecting the product to a power outlet, make sure that the power cord is not pinched or
damaged. Also make sure that the power output is within the voltage range of the product.

Connection to the mains supply

Once the product is installed, connect the product to an electrical outlet using the supplied power supply.
Make sure that the cable is firmly seated in the product. The charging process is indicated by an LED on
the front of the product.
1. Install the SIM card
2. Install the memory card
3. Install the battery (Rocktab S110 only)
4. Charge the device
5. Start the device
Install the SIM card
1. The card slots for SIM card and micro SD card are located under the cover with the SIM card symbol.
2. Carefully slide the SIM card into the slot until it clicks into place. The contacts must point to the back of
the device. Push the side with the bent corner at the end into the device.
above picture shows Rocktab S110
Rocktab S100 User Manual
60 / 76