Packing And Transport; Fitting The Appliance (Combi Unit + Wall-Mount Boiler) - Baxi Luna Duo-Tec Handbuch

SUPPLEMENTARY INSTRUCTIONS FOR THE INSTALLER
This manual supplements the one supplied with LUNA DUO-TEC and PLATINUM wall-mount boilers
The Combi unit is used to convert a heating-only wall-mount boiler into a base boiler that generates domestic hot water
thanks to a heater with a capacity of 80 litres made of AISI 316 L stainless steel.
The following technical instructions and notes are intended for installers so they may make a perfect
installation.
The instructions for igniting and using the boiler are given in the boiler manual.
The unit is sold on a wooden pallet protected by packing made of strengthened cardboard.
The packed unit must only be transported and lifted by holding it underneath the pallet.
CAUTION:
- This unit is to be combined with a heating-only boiler (LUNA DUO-TEC or PLATINUM), make sure that the boiler
model is the right one for the type of application.
- The bottom of the unit is secured to the wooden base with a screw.
To unscrew it, take off the cardboard packing and remove the door.
- The packing elements (plastic bags, polystyrene, etc.) must not be left within reach of children as they are potentially
hazardous.

2. FITTING THE APPLIANCE (Combi unit + wall-mount boiler)

Before installing the boiler it is necessary to fit the wall-mount boiler to the Combi unit.
To carry out this operation, proceed as indicated in figure 1 and in the following instructions:
Insert the side panels and the crosspiece only after finishing installing the appliance.
SUPPLEMENTARY INSTRUCTIONS
FOR THE INSTALLER
INTRODUCTION

1. PACKING AND TRANSPORT

2.1 ASSEMBLY OUTFIT ON THE COMBI UNIT
15
7113543.01 - en