Inhaltsverzeichnis
Werbung
All manuals and user guides at all-guides.com
2.11
2.11 Serial A
2.11
2.11
2.11
Serial A
Serial A
Serial A
Serial AT T T T T A3 (SA
A3 (SAT T T T T A3) Hard Disks Installation
A3 (SA
A3 (SA
A3 (SA
A3) Hard Disks Installation
A3) Hard Disks Installation
A3) Hard Disks Installation
A3) Hard Disks Installation
This motherboard adopts AMD SB850 chipset that supports Serial ATA3 (SATA3)
hard disks and RAID functions. You may install SATA3 hard disks on this
motherboard for internal storage devices. This section will guide you to install the
SATA3 hard disks.
STEP 1: Install the SATA3 hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA3 hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATA3
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA3 hard disk.
2.12 Hot Plug and Hot Swap F
2.12 Hot Plug and Hot Swap F
2.12 Hot Plug and Hot Swap Functions for SA
2.12 Hot Plug and Hot Swap F
2.12 Hot Plug and Hot Swap F
This motherboard supports Hot Plug and Hot Swap functions for SATA3 in RAID /
AHCI mode. AMD SB850 chipset provides hardware support for Advanced Host
controller Interface (AHCI), a new programming interface for SATA host controllers
developed thru a joint industry effort.
NOTE
What is Hot Plug Function?
If the SATA3 HDDs are NOT set for RAID configuration, it is called "Hot
Plug" for the action to insert and remove the SATA3 HDDs while the
system is still power-on and in working condition.
However, please note that it cannot perform Hot Plug if the OS has been
installed into the SATA3 HDD.
What is Hot Swap Function?
If SATA3 HDDs are built as RAID 1 or RAID 5 then it is called "Hot Swap"
for the action to insert and remove the SATA3 HDDs while the system is
still power-on and in working condition.
ASRock
870 Extreme3
unctions for SAT T T T T A3 HDDs
unctions for SA
unctions for SA
unctions for SA
A3 HDDs
A3 HDDs
A3 HDDs
A3 HDDs
Motherboard
3 1
3 1
3 1
3 1
3 1
Werbung
Inhaltsverzeichnis
