Wellis Cherokee Silver Trio Aufbauanleitung Seite 22

Troubleshooting:
EN
Problem
Grease fire or con-
tinuous excessive
flames above cooking
surface
Burner will not light
using ignitor
Burner will not light
using ignitor
Possible cause
Too much grease
buildup in burner
area
Gas issues
1. Trying to light
wrong burner
2. Burner not
engaged with
control valve
3. Obstruction in
burner
4. No gas flow
5. Vapor lock at
coupling nut
to LPtank
6. Coupling nut
ad LP tank
valve not fully
connected.
See "gas issues;"
on previous page.
2. Improper meth-
od of match-light-
ing
Prevention/ Solution
Turn off LP Tank. Leave
lid open to allow flames
to die down. After cool-
ing, clean food particles
and excess grease from
inside firebox area,
grease cup/pan/tray, and
other surfaces
1. See instructions on
control panel and
section in the Use
and Care.
2. Make sure valve are
positioned inside of
burner tubes.
3. Ensure burner tubes
are not obstructed
with spider webs or
other matted, see
cleaning section of
use and care
4. Make sure LP tank
is not empty. If LP
tank is not empty,
refer to "sudden
drop in gas flow.
5. Turn off knobs and
disconnect coupling
nut from LP tank.
Reconnect and retry.
6. Turn the coupling
nut approximate-
ly one-half to
three-quarters
1. See "Pilot Gas Con-
trol Ignition" section of
use and care.