WEEPLUG GPS EXPLORER 4 Bedienungsanleitung Seite 6

5. Fonctions
a) GPS
The GPS activates when you start any sporting activity except indoor running. Before you start your sporting activity,
the following logo will be displayed on your watch:
When the logo flashes green, the device is searching for a GPS connection. Your sports activity will
start automatically when a GPS network has been found. If the operation takes too long and your
watch cannot find a GPS network, go out into an open area and try again.
During your activity, if the "GPS" logo flashes at the top of your screen, your watch has not found a GPS network. If it is
fixed, it means that you are currently connected to a GPS network, and all your data will be transmitted to your
application if your watch and your phone are properly connected during your exercise.
b) Adjustment centre
c) Podometer
Your watch will calculate your number of steps daily. You can retrieve
this data by dragging up on the main menu. You will then be able to see
the number of kilometres travelled during the day or the number of
calories burned. You will also find a graph showing the number of
steps taken each week. Once your watch and smartphone are
synchronised, you'll find all this information on your application as
well.
d) Heart rate
Click on the following icon to access the heart rate sensor interface. Once on this page, the sensor will
automatically launch and calculate your heart rate. Wait a few seconds before obtaining a result. Check
that the watch is tight on your wrist and that the sensor is in contact with the skin. When your watch is
connected to the "Orunning" application, you can retrieve all the data from the application.
On the main menu, slide down to access some quick actions. You can
put your watch in "Do not disturb" mode, activate or deactivate
Bluetooth, manage the brightness of your screen. You can also access
other tesl settings other than "backlight time" or product information.
4