Maintenance And Cleaning - c 220USB-1F Bedienungsanleitung Und Sicherheitshinweise

Sliding Direction
CW
CW
CCW
Grip for switching
CAUTION: Do not look directly into the LED light.
Your eyes could be damaged.
CAUTION: Continually carrying out heavy loads
may cause malfunctions. If the work load is too heavy,
the product protection function will be activated. When the
product protection function is activated, the charging lamp
blinks and the product does not operate.
- Fully automatic spindle locking (Auto-lock): When the
switch is in neutral position, turning the power tool manually
will lock the spindle and tighten the screw. It allows the
screw to be tightened even when the battery is empty, which
allows the power tool to be used as a manual screwdriver.
Grip for hand tightening
CAUTION: Do not slide the switch while the
spindle is locked and the screw is manually tight-
ened. The power tool may be damaged.
- Working advice:
Apply the power tool to the screw only when it
is switched off. Rotating tool inserts can slip off.

MAINTENANCE AND CLEANING

Periodic inspection
- Loose screws, damage or malfunction.
CAUTION: Before any work (e. g., maintenance,
tool change,etc.) as well as during transport and
storage, set the rotational direction switch to the
neutral position. Unintentional actuation of the switch
can lead to injuries.
CCW
DISPOSAL
・Do not dispose of power tools as household
waste. Contact our distributor (without disas-
sembling) to dispose of used tools in an environ-
mentally safe way. Check the contact information
by QR code.
・If above is not possible, sort and dispose of used products
according to the rules of your area.
LED lighting
- Removal The lithium-ion battery used in this product is a
valuable resource that can be recycled. When disposing of the
battery or product, remove the battery and cooperate in
recycling.
- Battery removal
1) Disassemble as shown in the illustration.
2) Pull out the battery from the power tool and cut the two wires.
3) Insulate the positive and negative terminals of the removed
1)
2)
8
For safe and proper working, always keep the tool clean.
CAUTION: A reinforced plastic cover is used. Do
not use detergents or the following chemicals to
wipe the surface. Risk of cracks, electric shock, or
failure. - Benzine, Thinner, Ketone, Ether and other similar
chemicals
CAUTION: This product contains a lithium-ion battery.
Lithium-ion batteries that have reached their end of life after
prolonged use must be disposed of properly in accordance
with the national municipal treaty on ecological protection.
[Lithium-ion batteries are recyclable]
WARNING: Attach insulating tape to the terminal parts to
prevent short circuits.
WARNING: Do not throw the battery into fire. Do
not heat the battery. There is a risk of heat generation, fire,
and explosion.
Before removing a battery that has reached the end of its
useful life, turn it on and fully discharge the battery until the
motor stops working.
Cut the wires one by one.
battery with tape.
Use a Torx T10 screwdriver.
®
3)