Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USE INSTRUCTIONS / FUNCTIONS
HEIGHT ADJUSTMENT
PROCEDURE
1.
2.
Loosen the locking
Retract the safety
knob slightly
pin until the frame
is free to be
repositioned
TILT
DIMENSIONS
CHECKS, MAINTENANCE, CLEANING
- Ensure the keyboard stand is on level ground for maintenance work and be aware of potential hazards
- Use a non-scouring cleaning formula and preferably a slightly damp cloth for cleaning
(FF) FAULT FINDING and (R) REPAIR
FF: Stacker wobbles
FF: Stacker stands at an angle R: Ensure the support arms 1 are set at the same height i.e. the same tilt.
TECHNICAL DATA/SPECIFICATIONS
Tubes: steel, black powder coated
Materials
Screws, washers: steel, zinc plated
Plastic components: PA, TPE, black
Dimensions
Support arm width: 40 mm, support arm depth: 400/330 mm, height: 262 - 375 mm
Weight
4.0 kg
Packing
L x W x H: 470 x 325 x 90 mm
All manuals and user guides at all-guides.com
3.
Slide the support
arm up or
down
a. Select the required bore holes
b. Position the carriage bolt
c. Extend the strut
d. Slot the carriage bolt through the bar
d.
and strut, secure with a locking knob
Height adjustment:
- 10 levels
- Distance: every 12.5 mm
R: Tighten locking knobs 3. R. Tighten the keyboard stand's screw connections 4, 5, 7.
R:
Ensure you are using the same holes.
4.
Ensure the safety pin
has re-engaged in
the required bore
hole and tighten the
locking knob
USES
A
e.g. for a laptop
- Short pieces of equipment
- The support arms
-
18810 remain on the
-
stand
B
e.g. for a 2nd laptop
- Wider pieces of
-
equipment
- Support arms 18810
-
can be removed
The arms can be
positioned to 10
different heights.
Werbung
