Possible Cause - Lehner Versand KYQ-6ST-B Montage- Und Bedienungsanleitung

COOKING GRID
Use a mild soapy water solution. Non-abrasive scouring power can be used on stubborn stains then rinse
with water.
CLEANING THE BURNER ASSEMBLY
Turn the gas OFF at the control knob
and disconnect the cylinder.
Remove cooling grate.
Clean the burner with a soft brush or
blow clean with compressed air and
wipe with a cloth.
Clean any clogged ports with a pipe
cleaner or stiff wire (such as an
opened paper clip).
Inspect burner for any damage (cracks or holes). If damage is found, replace with a new burner. Reinstall
the burner, check to ensure that the Gas valve orifices are correctly positioned and secured inside the
burner inlet (venturi).
SERVICING
Your gas barbecue should be serviced annually by a competent registered person.
TROUBLE SHOOTING
PROBLEM
Burners will not light using the
ignition system
Burner will not light with a
match
Low flame or flashback (fire in
burner tube-a hissing or
roaring noise may be heard)
PLEASE NOTE THE BURNER DIRECTION
THIS SIDE UP

POSSIBLE CAUSE

1. gas cylinder is empty
2.faulty regulator
3.obstructions in burner
4.obstructions in gas jets or gas hose
5. electrode wire loose or disconnected
on electrode or ignition unit
6.electrode or wire is damaged faulty
pushbutton igniter
1. gas cylinder is empty
2.Faulty regulator
3.Obstructions in burner
4.Obstructions in gas jets or gas hose
1. gas cylinder too small
2.Obstructions in burner
3.Obstructions in gas jets or gas hose
4.Windy conditions
16
SOLUTION
1.replace with full cylinder
2.have regulator checked or
replace
3.clean burner
4.clean jets and gas hose
5.reconnect wire
6.change electrode and wire
change igniter
1.Replace with full cylinder
2.Have regulator checked or
replace
3.Clean burner
4.Clean jets and gas hose
1.Use larger cylinder
2.Clean burner
3.Clean jets and gas hose
4.Use BBQ in a more
sheltered position