Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
- GB -
Warnings used in these instructions
NOTE
Information for the purpose of clarification or for preventing possible damage to assets or to the environment.
Cross-references used in these instructions
A
reference to a figure, e.g. figure A.
Reference to another section.
Scope of delivery
A
Quantity
1
1
2
3
3
1
4
1
5
1
6
1
7
1
8
1
Intended use
NPSTP-O 600, referred to as "unit", may only be used as specified in the following:
For creating a water fountain in a pond.
For operation with clean water.
Operate in accordance with instructions.
The following restrictions apply to the unit:
Never use the unit with fluids other than water.
Never run the unit without water.
Do not use for commercial or industrial purposes.
Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Installation and connection
How to proceed:
B
1. Assemble the nozzle unit and the LED lighting and fit onto the pump.
– Adapt the number of nozzle extensions used to the depth of the pond.
2. Connect the connection cables of the pump and LED lighting to the solar module. (→ Commissioning/start-up)
– Push each plug into the socket as far as possible to ensure that the connection is watertight.
3. Assemble the ground stake set and attach it to the solar module.
– Align the solar module such that the sockets with the connection cables point downwards.
4. Install the solar module so that it is exposed to direct sunlight.
– Recommendation: Align the solar module to the sun to ensure maximum energy yield.
5. Install the unit in the pond in a horizontal position on firm, sludge-free ground and ensure that it is completely cov-
ered with water.
Description
Pump with 5 m connection cable
Nozzle extension
Nozzle
Nozzle holder with nozzle attachment
Solar module
Ground stake set
Remote control
LED lighting with 5 m connection cable
- GB -
11
Werbung
Inhaltsverzeichnis
