Laserworld Club Serie Bedienungsanleitung Seite 7

Manual: Club Series CS-2000RGB FX | CS-4000RGB FX
Master Setting
The „uAST" menu allows for the activation and deactivation of the Master mode for the laser.
If the laser is set to Master > On, then it can be used as Master device in a Master-Slave setup.
See more in „8.2.3. Master-Slave".
Press „Enter" to change the settings. Use the „Up" / „Down" button to change the selection.
Confirm with „Enter".
Safety Setting
The „bEAu" menu can switch the beam block safety on and off. The beam block safety
prevents that very intense, single beams can be displayed. It is highly recommended to not
switch this feature off. Switching off the beam block safety is at your own risk! Lasers with
switched off beam block safety may only be used in safe areas.
Always respect the local laws!
Press „Enter" to change the settings. Use the „Up" / „Down" button to change the selection.
Confirm with „Enter".
Orientation Setting
The „InuE" menue controls the orientation of the projection. You can invert the projection
and flip it to match the orientation of the laser with the content.
Press „Enter" to change the settings. A test picture is shown to represent the currently set
orientation. Use the „Up" / „Down" button to change the selection, and confirm the selection
with „Enter" to change the test picture projection
Press „Exit" to return to the settings menu.
page 8 / 10
English
Microphone Sensitivity Settings
The sensitivity of the built-in microphone for the control of the sound-to-light operation can
be adjusted in the „SEnS" menu. Press „Enter" to change the settings. Use the „Up" / „Down"
button to change the selection.
The sensitivity can be adjusted between 1 and 100. Standard value is 50.
4.6. ILDA / COMPUTER CONTROL
The laser can be used with any laser control software that supports the ILDA control signal
via sub-d connector. Use an ILDA cable to connect the Digital Analog Converter (DAC / ILDA
interface) of the laser software to the ILDA in port at the laser.
To operate the laser in ILDA mode the „ILdA" menu must be selected. Press „Enter" to change
the settings.
a
Grating Effects Settings in ILDA mode - DMX grating control on ILDA
Once ILDA mode is selected, the standard selection is „L001", which means that the laser will
automatically switch through the grating effects. A certain grating effect can be selected
with L002, L003, L004. If L005 is selected there is no grating effect.
Use the „Up" / „Down" button to change the selection:
Select „d512" and press Enter if you want to control grating effects with DMX while working
on ILDA mode. You must previusloy set a DMX address as specified in „4.4 DMX 512" section.
Manual: Club Series CS-2000RGB FX | CS-4000RGB FX
English
page 9 / 10