Laserworld Club Serie Bedienungsanleitung Seite 6

Manual: Club Series CS-2000RGB FX | CS-4000RGB FX
Use the „Up" / „Down" buttons to navigate to „uASt"
Press „Enter", use the „Up" / „Down" buttons to switch the option to „on" and confirm with
„Enter"
C: Deactivate Master setting on Slave lasers
As soon as the Master option is set to „on", the laser sends out the control signal for the Slave
units. Make sure that all Slave units have the Master setting set to „oFF":
D: Set Sound-to-Light or Auto mode on Master laser
To use the Master-Slave operation: set the Master to either Sound-to-Light mode (8.2.1) or
Auto mode (8.2.2.).
E: Establish link to Slave lasers
The Slave units must be set to DMX („d512") mode and must be assigned address 001 (see
8.2.4. DMX 512)
4.4. DMX 512
The DMX mode requires a DMX controller or a Master laser (see 8.2.3. Master-Slave operation)
to be connected to the laser.
To switch to DMX mode, select „d512" by navigating with the „Up" / „Down" buttons and
confirm with „Enter":
The submenu for setting the DMX address loads:
Press „Enter" and the „Up" / „Down" buttons to set the desired DMX address.
Confirm with „Enter" and press „Exit" to return to the main menu.
page 6 / 10
English
DMX Chart
The laser uses 14 DMX channels, so make sure that the next device uses an address that doesn't
overlap with this range.
Channel
1
2
3
4
5
6
7
8
9
10
11
12
13
14
4.5. SETTINGS
To access the settings, select „SEt" by navigating with the „Up" / „Down" buttons and confirm
with „Enter":
The settings menu holds several configuration options for the laser system.
Manual: Club Series CS-2000RGB FX | CS-4000RGB FX
Value Function
Operation mode 0 - 49 Laser off
50 - 99 Sound-to-Light mode
100 - 149 Stand-alone mode
150 - 255 DMX mode
Pattern select 0 - 255 Pattern selection (refer pages 44 – 46 for full
pattern overview)
Rotation (Z-axis) 0 - 127 Rotation angle selection
128 - 191 Rotation counter-clockwise speed
192 - 255 Rotation clockwise speed
X-axis Rotation 0 - 127 Rotation X position steps
128 - 255 Rotation X speed
Y-axis Rotation 0 - 127 Rotation Y position steps
128 - 255 Rotation Y speed
X-axis Movement 0 - 127 X-axis movement position
128 - 255 X-axis movement speed
Y-axis Movement 0 - 127 Y-axis movement position
128 - 255 Y-axis movement speed
Size X 0 - 255 Size X from big to small
Size Y 0 - 255 Size Y from big to small
Pattern gradient 0 - 255 Gradient speed
Scan speed / Points 0 - 127 Scan speed
128 - 255 Point speed
Color change 0 - 24 Original color
25 - 199 Color selection
200 - 224 Automatic color change effect
225 - 255 Rainbow color change effect
Color speed 0 - 255 Speed adjustment for automatic color change
effect and multi color step through
Grating effect 0 - 255 cycle through grating effects per 50 value
English
page 7 / 10