Problems Solution - Lacor PRO 69320 Gebrauchs- Und Instandhaltungsanleitung

Problem
The ice maker does not work
The insufficient water indica-
tor is on
The compressor does not
work
The compressor works but
no ice is being made
The ice does not drop easily
Problems with the indicator
lights
26
PROBLEMS SOLUTIONS
Possible Cause
1.- Inadequate power supply
range
2.- The room temperature is
below 10ºC
1- There is not enough water
in the water supply system
2.- Damaged water input
valve
3.- The tap water pressure is
too low
1.- Insufficient water
2.- The ice container is full
1.- Coolant leaks
2.- The cooling system is
blocked
1.- The water temperature or
the room temperature is too
low.
2.- The valve is damaged
The water container is not
inclined
Solution
1.- Stop the machine and
restart it. Check the voltage
2.- Try again once the room
temperature is above 10ºC
1- Check the water supply. If it
is correct, restart the machine
2.- Check the water input
valve
3.- Make sure that the tap
water pressure is greater than
1 kg/cm2
1.- Check the water supply
system
2.- Remove some of the ice
1.- Recharge with additional coolant and check the
output again
2.- Charge with N2 to check the system for block-
ages and replace the filter
3.- Replace the valve
4.- Make sure that the fan is working
1.- Check whether the room tem-
perature (10ºC) and the water
temperature (7ºC) are too low
2.- Replace the valve
Disconnect the power sup-
ply and make sure that the
motor is not inclined. Allow
for 3-4 minutes to pass and
restart the machine