Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Making of ice cubes
UNPACKING
1.- Open the box and remove all the packaging materials, the device's protective cover and its
accessories.
2.- Remove all accessories and book instructions.
3.- Place the device on a hard surface, flat and level.
4.- Please make sure that you clean all parts that come into contact with food with soapy water,
and then dry.
5.- For a correct installation, make sure to identify among the accessories a corrugated tube with
a 12 mm diameter for drainage as well as a hose with two different connections for water input.
6.- First, connect one end of the drainage tube to the drainage valve (9).
The other end of the tube must lead to a drain. Keep in mind that there must be a difference
in height to facilitate the removal of water.
7.- Attach one end of the water hose to the coupling located on the copper water output tube and
the other end to the water input valve located on the ice maker (8).
NOTE: The water pressure should be between a minimum of 1kg/cm or 14.7 psi and a maximum
of 8 kg/cm or 117 psi.
1 2 3
24
MAIN FUNCTION
INSTALLATION
PARTS LIST
4
6
5
1- ON/OFF switch
2- Front panel
3- Door
4- Ice drop platform
5- Ice container
6- Ice level sensor
7- Power cable
8- Water input valve
7
9- Drainage valve
10- Rubber feet
8
9
10
Werbung
Inhaltsverzeichnis
