Project Food AKD200R Handbuch Zur Installation, Bedienung Und Wartung Seite 26

Display the set temperature (set point)
Press the SET button once: the "VIEW" light lights up and the display shows the actual set
temperature. Press the SET button or do no press any key for 15 seconds to exit the view mode.
Temperature setting (set point)
Press the SET button for 3 seconds to enter the settings menu: the "SET" light lights up and the
display shows the actual set temperature.
Proceed as follows to change the temperature setting:

Press the ▲(UP) or ▼(DOWN) button within 15 seconds to increase or decrease the set
temperature, respectively, until the new temperature has been reached.

Press the SET button or do not press any key for 15 seconds to save the new value and exit
the settings menu.
N.B. When running, the appliance will cool the cell until the currently set operating temperature
is reached. Once the set operating temperature is reached, the electronic control unit will turn
off the cooling unit until the temperature detected by the probe rises by about 4-5 degrees.
When this happens, the control unit will turn on the cooling unit to lower the temperature until
it returns to the set operating temperature.
This "on-off" mechanism is perfectly normal and is common in all refrigeration equipment such
as refrigerated bars, cabinets, display cases, etc.
Please note that the temperature shown on the control unit display refers to the air
temperature (very susceptible to temperature changes due to the opening of the door) and not
to the temperature at the core of the appliance, which is much more constant over time.
Internal light
Models with glass door (versions RG, RG SS and FG) are equipped with internal light. Proceed as
follow to turn on or off the light:

Open the door;

Press the switch located in the upper part of the door stop frame.
Error messages displayed on the control unit:
MESSAGE
E1
If one or more error codes are displayed, write them down, turn off the appliance then turn it back
on after 3-4 minutes. If one or more of the codes are again displayed, contact the dealer to
request technical support and inform them of the error codes.
Food storage
The following instructions should be followed in order for the appliance to perform at its best:

Put the food into the appliance after it has reached the desired temperature displayed on the
control unit. To avoid restricting air circulation, do not put too many products in the upper
part of the refrigerator.

Do not place hot foods inside the appliance (they must be previously cooled in a blast chiller)
or in unclosed containers. Always package and protect foods before putting them in the
refrigerator.

Avoid opening and door frequently and for prolonged periods of time, and wait at least 30
seconds before re-opening the door.
- 26 -
ERROR DESCRIPTION
Faulty temperature probe
EFFECT
The temperature is no
longer being adjusted
correctly.
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
SOLUTION
Contact the
dealer
INSTRUCTIONS