Interlogix Advisor Advanced ATS 500A-Serie Installationsanleitung Seite 3

6 Install
Choose OK
>Cancel<
Change PIN
Press Enter to continue
Installer
New PIN
Enter the new installer PIN and press
>_
Enter
Verify
Next, enter the PIN again to verify it.
>_
Change PIN
Press Enter to continue
Supervisor
New PIN
Enter the new supervisor PIN and
>_
press Enter
Verify
Next, enter the PIN again to verify it.
>_
The panel restarts.
Auto configuration
Auto Config?
Press Enter to continue.
>Yes<
Rkp 1-16 BUS1
Wait until the panel configures all bus
R-?-------------
devices and zones.
Exp 1-15 BUS1
-?-------------
Aud 1-16 BUS1
---?------------
Added
Press Enter to continue.
R:1 D:0 Z:8
A:0
Enabling service in
UTC F&S
Enter the supervisor PIN and press
THU 05 Mar 12:21
Menu
1>Zone options
Go to menu 8.8 Service in
2 Isolate
8>Service in
Enable Installer in time
Enable?
Press Cancel, Cancel to log off.
Programming menu entry
UTC F&S
Enter the installer PIN and press Menu
THU 05 Mar 12:21
Inh reports
Press Enter to continue
>No<
Inh tampers
Unset areas
1>Service menu
2 Device menu
The installer menu is displayed.
P/N 466-2523 (ML) • REV D • ISS 16JUN17
All manuals and user guides at all-guides.com
Changing encryption key
Caution: It is highly recommended to change the default
encryption key.
Go to 9.4.3 Encryption key 1 and 9.4.4 Encryption key 2.
3 Encrypt.key 1
Provide encryption key 1.
>000000000000<
4 Encrypt.key 2
Provide encryption key 2.
>000000000000<
Configuring zones
Go to 4.1 Zone menu.
4>Zones&Areas
Press Enter.
1>Zone menu
Press Enter.
0>Add zone
Select a zone.
1 Zone 1
For each zone used in the system, enter zone name in 4.1.n.1
Zone name.
01 Zone name
>1 Zone 1 <
Next, set its zone type in 4.1.n.2 Zone type.
02 Zone type
>Entry/Exit 1<
Adding users
Go to menu 3.1 Users.
0>Add user
Press Enter to add a user.
1 Installer
Add mode
Press Enter.
>Manual<
INFO
User added
01>User name
Press Enter.
User 3
01 User name
Enter a new user name.
>User 3 <
Configure other options of the user:
•
3.1.n.2 PIN
•
3.1.n.3 User card
•
3.1.n.6 User groups, etc.
Repeat for other users.
When leaving the user configuration, confirm locking the user
data.
Lock user data?
Choose OK and confirm.
>Cancel<
Configuring areas
Go to 4.2 Areas menu.
3 / 42